MOTORSPORT SERVICE


 We offer full services for Ski-Doo snowmobiles by trained mechanics along with general maintenance services for other brands of snowmobiles.  General maintenance services are also available for ATV's, motorcycles, and trailers. 

Labor Rate : $55 / Hour

  

SNOWMOBILE PRE SEASON SERVICES


TYPE 1

TYPE 2

TYPE 3

Fuel Inj: $60  Twin & 4-Stroke: $85  Triple: $110

Plus parts, grease, fluids and filter 

Fuel Inj: $85  Twin & 4-Stroke: $120  Triple: $145

 Plus parts, grease, fluids and filter

Twin and 4-Stroke: $280  Triple: $320

 Plus parts, grease, fluids and filter
Check for Service/Warranty Bulletins Includes Type 1 and the following Includes Type 1, 2, and the following
General Inspection Check suspension condition & torque strap Compression and Air Leak Test
Grease Chassis, Lube Steering Check idler wheels, bearings, sliders Injection oil filter replacement
Clean Plugs (replace if necessary) Check ski & runner condition Remove and Clean Clutches
Remove & Clean Carburetors Check steering components & Front suspension Complete Wash & Wax
Check fuel lines & Carb. boots Check & Charge battery (if applicable)  
Check lights, tether, kill, ignition switches Check starter rope condition  
Change Oil and Filter (4-Stroke) Check condition of throttle cable  
  Check braking system & adjust  
  Adjust drive chain  
  Check fan belt condition (if applicable)  
  Check coolant level and condition (if applicable)  
  Check Injection oil pump & lines, adjust  
  Check Clutch bolt  
  Check Clutch alignment  
  Check Bumpers  
  Check Driven pulley pre-load  
  Check track tension & alignment  
  Check ski alignment  
  Replace Chain Case oil  
  Check RAVE valve movement  
  Wash  


All prices are labor only for checks performed, if a problem is found the customer will be notified and additional parts and labor will be extra. Oil injection container and fuel tanks are not filled unless instructed to do so by customer. All work is performed by Ski-Doo Certified technicians.


Snowmobile summer storage

$40 or Less

Quick visual check over for any obvious problems

Add fuel stabilizer

Remove Belt

Apply penetrating fluid to ALL corrodible surfaces

Lube tie rod ends with lithium grease

Grease all Zerk fittings

Disconnect negative battery terminal (either end)

Put rags in exhaust & air box openings

Wash, apply cover (if supplied with) 


garneausgarage@yahoo.com